National Highway Traffic Safety Administration |
|
49 CFR 572.186(a) |
Drawing No. 175-5000 |
2009 |
Abdominal Assembly
|
National Highway Traffic Safety Administration, U.S. Department of Transportation |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IA Footnote 18 |
Colilert-18® Method |
2010 |
Coliform/E. coli detection kit
|
IDEXX Laboratories |
Environmental Protection Agency |
|
40 CFR 436.41(c) |
NWS Technical Paper No. 40 |
1961 |
Rainfall Frequency Altas of the U.S.
|
U.S. Department of Commerce, National Oceanic and Atmospheric Administration |
Environmental Protection Agency |
|
40 CFR 86.1(g)(11) |
SAE J-1939-13 |
2004 |
Off-Board Diagnostic Connector
|
Society of Automotive Engineers |
Environmental Protection Agency |
|
40 CFR 75, Appendix F, Section 3.3.6.1 |
ASTM D3176 |
2002 |
Standard Practice for Ultimate Analysis of Coal and Coke
|
ASTM International |
Coast Guard |
|
46 CFR 160.040-2(c) |
MIL-R-45505 |
1971 |
Line Throwing Apparatuses, Rocket and Projectile Units
|
U.S. Department of Defense |
National Highway Traffic Safety Administration |
|
49 CFR 571.108 S9.3.5 |
SAE J-941b |
1969 |
Motor Vehicle Driver's Eye Range
|
Society of Automotive Engineers |
Environmental Protection Agency |
|
40 CFR 60.111a(b) Petroleum liquids |
ASTM D396 |
1990 |
Standard Specification for Fuel Oils
|
ASTM International |
Occupational Safety and Health Administration |
|
29 CFR 1915.134(c) |
ANSI B7.1 |
1964 |
Safety Code for the Use, Care and Protection of Abrasive Wheels
|
American National Standards Institute |
Environmental Protection Agency |
|
40 CFR 86.1806-05(h)(1)(iii) |
ISO 9141-2 |
1994 |
Road Vehicles--Diagnostic Systems
|
International Organization for Standardization |
Nuclear Regulatory Commission |
|
10 CFR 50.48(c)(3)(i) |
NFPA 805 |
2001 |
Performance-Based Standard for Fire Protection for Light Water Reactor Electric Generating Plants
|
National Fire Protection Association |
Coast Guard |
|
46 CFR 30.10-27 Table 30.10-27 |
ASTM D93 |
1994 |
Standard Test Methods for Flash Point by Pensky-Martens Closed Cup Tester
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IC (19) |
EPA Method 601 |
1982 |
Purgeable Halocarbons
|
U.S. Environmental Protection Agency |
Engineers Corps |
|
33 CFR 222.3(c)(2) |
ANSI C2 |
2012 |
National Electrical Safety Code
|
American National Standards Institute |
Housing and Urban Development Department |
|
24 CFR 200, Appendix A |
FGMA Publication |
1990 |
FGMA Sealant Manual
|
Flat Glass Marketing Association |
Coast Guard |
|
46 CFR 56.60-1(b) Table 56.60-1(a) |
ASTM A47 |
1990 |
Standard Specification for Ferritic Malleable Iron Castings
|
ASTM International |
Coast Guard |
|
46 CFR 160.135-11(c)(2)(ii) |
ASTM A653/A 653M |
2008 |
Standard Specification for Steel Sheet, Zinc-Coated (Galvanized) or Zinc-Iron Alloy-Coated (Galvannealed) by the Hot-Dip Process
|
ASTM International |
Minerals Management Service |
|
30 CFR 250.1202(a)(3)(i) |
API MPMS |
2002 |
Chapter 4, Section 8
|
American Petroleum Institute |
Coast Guard |
|
33 CFR 154.106(d)(2) |
ASTM F715 |
1995 |
Standard Test Methods for Coated Fabrics Used for Oil Spill Control and Storage
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table ID (63) |
USGS O-3106-93 |
1993 |
Methods of Analysis by the U.S. Geological Survey National Water Quality Laboratory--Determination of Triazine and Other Nitrogen-containing Compounds by Gas Chromatography with Nitrogen Phosphorus Detectors
|
U.S. Geological Survey |
Environmental Protection Agency |
|
40 CFR 147.650(a)(11) |
IDUIC regulations |
1984 |
Rules and Regulations: Construction and Use of Injection Wells, Idaho Department of Water Resources, Rules 1 through 14 (August 1984)
|
State of Idaho |
Environmental Protection Agency |
|
40 CFR 63.10885(a)(1) |
EPA Method 9095B |
2004 |
Paint Filter Liquids Test, Revision 2
|
U.S. Environmental Protection Agency |
Food and Drug Administration |
|
21 CFR 165.110(b)(4)(iii)(F)(7) |
EPA Method 505 |
1989 |
Analysis of Organohalide Pesticides and Commercial Polychlorinated Biphenyl (PCB) Products in Water my Microextraction and Gas Chromatography
|
U.S. Environmental Protection Agency |
Research and Special Programs Administration |
|
49 CFR 178.358-2(b) |
DOE CAPE-1662 |
1988 |
Civilian Application Program Engineering Drawings, Revision 1 and Supplement 1
|
U.S. Department of Energy |
Pipeline and Hazardous Materials Safety Administration |
|
49 CFR 192.113 |
ASTM A691 |
2002 |
Standard Specification for Carbon and Alloy Steel Pipe, Electric-Fusion-Welded for High-Pressure Service at High Temperature
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IC (74) |
EPA Method 625 |
1982 |
Base/Neutrals and Acids by GC/MS
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 141.66(h) Table C Note 1 |
NRC Publication |
1997 |
Safe Water from Every Tap: Improving Water Service to Small Communities
|
National Research Council |
Environmental Protection Agency |
|
40 CFR 61, Appendix B, Method 114, 5(5) |
APHA Method 608 |
2015 |
Tentative Method of Analysis for Strontium90 Content of Atmospheric Particulate Matter
|
American Public Health Association |
Energy Department |
|
10 CFR 430.2, Definitions, Ballast efficacy factor |
ANSI C82.2 |
2002 |
Fluorescent Lamp Ballasts--Methods of Measurement
|
American National Standards Institute |
Safety and Environmental Enforcement Bureau |
|
30 CFR 250.198(h)(14) |
API MPMS |
2003 |
Chapter 4, Section 6
|
American Petroleum Institute |
Coast Guard |
|
46 CFR 160.051-7(j) |
IMO Revised recommendation on testing |
2010 |
Life-Saving Appliances, including LSA Code, Revised recommendation on testing of live-saving appliances, pages 79-254
|
International Maritime Organization |
Rural Utilities Service |
|
7 CFR 1755.910(d)(5)(ix) |
ASTM B633 |
1985 |
Standard Specification for Electrodeposited Coatings of Zinc on Iron and Steel
|
ASTM International |
Health and Human Services Department |
|
45 CFR 162.1402(b)(1) |
ASC X12N 276/277 |
2000 |
Health Care Claim Status Request and Response
|
Washington Publishing Company |
Safety and Environmental Enforcement Bureau |
|
30 CFR 250.862(e) |
API RP 505 |
1997 |
Recommended Practice for Classification of Locations for Electrical Installations at Petroleum Facilities Classified as Class I, Zone 0, Zone 1, and Zone 2
|
American Petroleum Institute |
Food and Drug Administration |
|
21 CFR 184.1408(b)(1) |
AOAC Official Methods |
1980 |
Official Methods of Analysis
|
AOAC International |
Coast Guard |
|
46 CFR 114.600(b) |
Resolution A.658(16) |
1989 |
Use and Fitting of Retro-Reflective Materials on Life-Saving Appliances
|
International Maritime Organization |
National Highway Traffic Safety Administration |
|
49 CFR 572.111(a) |
Drawing No. 96-SIDH3-001 |
1996 |
Head-Neck Bracket
|
Reprographic Technologies |
Rural Utilities Service |
|
7 CFR 1755.390(i)(5)(v) |
ASTM B694 |
1986 |
Standard Specification for Copper, Copper Alloy, and Copper-Clad Stainless Steel Sheet and Strip for Electrical Cable Shielding
|
ASTM International |
National Highway Traffic Safety Administration |
|
40 CFR 136.3(a) Table IB (16) |
APHA Method 4500-Cl E |
1997 |
Chlorine by Low-Level Amperometric Titration Method
|
American Public Health Association |
Pipeline and Hazardous Materials Safety Administration |
|
49 CFR 171.7(a)(3) |
ISO 9809-1 |
1999 |
Gas Cylinders--Refillable Seamless Steel Gas Cylinders--Design, Construction and Testing--Part 1: Quenched and Tempered Steel Cylinders with Tensile Strength less than 1 100 MPa
|
International Organization for Standardization |
Safety and Environmental Enforcement Bureau |
|
30 CFR 250.198(h)(88) |
API RP 86 |
2005 |
Recommended Practice for Measurement of Multiphase Flow; First Edition
|
American Petroleum Institute |
Housing and Urban Development Department |
|
24 CFR 3280.4(a) |
NFPA All Standards |
2013 |
All specifications, standards and codes without specific reference
|
National Fire Protection Association |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IB (51) |
EPA Method 255.2 |
1978 |
Platinum (Atomic Absorption, Furnace Technique)
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 141.23(k)(1) Table (19) Nitrite |
EPA Method 353.2 |
1993 |
Determination of Nitrate-Nitrite Nitrogen by Automated Colorimetry, Revision 2.0
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 60.17(g)(184) |
ASTM D6522 |
2000 |
Standard Test Method for Determination of Nitrogen Oxides, Carbon Monoxide, and Oxygen Concentrations in Emissions from Natural Gas-Fired Reciprocating Engines, Combustion Turbines, Boilers, and Process Heaters Using Portable Analyzers
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 1065.710 Table 1 |
ASTM D4815 |
2013 |
Standard Test Method for Determination of MTBE, ETBE, TAME, DIPE, tertiary-Amyl Alcohol and C1 to C4 Alcohols in Gasoline by Gas Chromatography
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 136.3(b)(8)(xi) |
EPA Method 1664 |
2010 |
n-Hexane Extractable Material (HEM; Oil and Grease) and Silica Gel Treated n-Hexane Extractable Material (SGT-HEM; Non-polar Material) by Extraction and Gravimetry. Revision B, EPA-821-R-10-001
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 763 Appendix A (II)(J)(4) |
DOI/BOM Information Circular 8751 |
1977 |
Selected Silicate Minerals and Their Asbestiform Varieties, Campbell, W.J., R.L. Blake, L.L. Brown, E.E. Cather, and J.J. Sjoberg
|
Bureau of Mines, U.S. Department of Interior |
Environmental Protection Agency |
|
40 CFR 98.164(b)(5)(ii) |
ASTM D1946 |
2006 |
Standard Test Method for Analysis of Reformed Gas by Gas Chromatography
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 266.106(g)(2) |
EPA Method 0061 |
1996 |
Determination of Hexavalent Chromium Emissions from Stationary Sources
|
U.S. Environmental Protection Agency |