| Environmental Protection Agency |
|
40 CFR 1060.810(b) Table 2 |
SAE J-30 |
1998 |
Fuel and Oil Hoses
Archived
|
Society of Automotive Engineers |
| Environmental Protection Agency |
|
40 CFR 1060.810(a) Table 1 |
ASTM D4806 |
2007 |
Standard Specification for Denatured Fuel Ethanol for Blending with Gasolines for Use as Automotive Spark-Ignition Engine Fuel
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 1060.810(b) Table 2 |
SAE J-2659 |
2003 |
Test Method to Measure Fluid Permeation of Polymeric Materials by Speciation
Archived
|
Society of Automotive Engineers |
| Environmental Protection Agency |
|
40 CFR 1060.810(c) Table 3 |
California Code of Regulations |
2004 |
Final Regulation Order, Article 1, Chapter 15, Division 3, Title 13
Archived
|
California Air Resources Board |
| Environmental Protection Agency |
|
40 CFR 1060.810(b) Table 2 |
SAE J-2260 |
1996 |
Non-metallic Fuel System Tubing with One or More Layers
Archived
|
Society of Automotive Engineers |
| Environmental Protection Agency |
|
40 CFR 1060.810(d) Table 4 |
ABYC H-25 |
2010 |
Portable Marine Gasoline Fuel Systems
Archived
|
American Boat and Yacht Council |
| Environmental Protection Agency |
|
40 CFR 63.14(k)(4) |
DE State Regulations |
2000 |
Letter of June 7, 1999, to the U.S. Environmental Protection Agency Region 3 from the Delaware Department of Natural Resources and Environmental Control
Archived
|
State of Delaware |
| Environmental Protection Agency |
|
40 CFR 92.5(a)(1) |
ANSI B109.1 |
1992 |
Diaphragm Type Gas Displacement Meters
Archived
|
American National Standards Institute |
| Environmental Protection Agency |
|
40 CFR 92.5(b)(1) |
ASTM D86 |
1995 |
Standard Test Method for Distillation of Petroleum Products at Atmospheric Pressure
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 89.6(a)(2) |
ASTM D93 |
2009 |
Standard Test Method for Flash Point by Pensky-Martens Closed Cup Tester
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 92.5(b)(2) |
ASTM D93 |
1994 |
Standard Test Method for Flash Point by Pensky-Martens Closed Cup Tester
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 91.6(b)(1) Table |
ASTM D323 |
1990 |
Standard Test Method for Vapor Pressure of Petroleum Products (Reid Method)
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 92.5(b)(4) |
ASTM D445 |
1994 |
Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 92.5(b)(5) |
ASTM D613 |
1995 |
Standard Test Method for Cetane Number of Diesel Fuel Oil
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 92.5(b)(6) |
ASTM D976 |
1991 |
Standard Test Method for Calculated Cetane Index of Distillate Fuels.
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 92.5(b)(7) |
ASTM D1319 |
1995 |
Standard Test Method for Hydrocarbon Types in Liquid Petroleum Products by Fluorescent Indicator Adsorption
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 92.5(b)(8) |
ASTM D1945 |
1991 |
Standard Test Method for Analysis of Natural Gas by Gas Chromatography
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 92.5(b)(9) |
ASTM D2622 |
1994 |
Standard Test Method for Sulfur in Petroleum Products by Wavelength Dispersive X-ray Fluorescence Spectrometry
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 90.7(b)(1) Table |
ASTM D2699 |
1992 |
Standard Test Method for Knock Characteristics of Motor Fuels by the Research Method
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 91.6(b)(1) Table |
ASTM D2699 |
1992 |
Standard Test Method for Knock Characteristics of Motor Fuels by the Research Method
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 90.7(b)(1) Table |
ASTM D2700 |
1992 |
Standard Test Method for Knock Characteristics of Motor and Aviation Fuels
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 91.6(b)(1) Table |
ASTM D2700 |
1992 |
Standard Test Method for Knock Characteristics of Motor and Aviation Fuels
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 90.7(b)(1) Table |
ASTM D3231 |
1989 |
Standard Test Method for Phosphorous in Gasoline
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 91.6(b)(1) Table |
ASTM D3231 |
1989 |
Standard Test Method for Phosphorous in Gasoline
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 92.5(b)(10) |
ASTM D5186 |
1991 |
Standard Test Method for Determination of Aromatic Content and Polynuclear Aromatic Content of Diesel Fuels and Aviation Turbine Fuels by Supercritical Fluid Chromatography
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 90.7(b)(1) Table |
ASTM D5191 |
1993 |
Standard Test Method for Vapor Pressure of Petroleum Products (Mini Method)
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 94.5(b)(1) |
Annex VI of MARPOL 73/78 |
1997 |
Resolution 2—Technical Code on Control of Emission of Nitrogen Oxides from Marine Diesel Engines
Archived
|
International Maritime Organization |
| Environmental Protection Agency |
|
40 CFR 94.5(c)(1) |
ISO 8178-1 |
1996 |
Reciprocating internal combustion engines—Exhaust emission measurement—Part 1: Test-bed measurement of gaseous and particulate exhaust emissions
Archived
|
International Organization for Standardization |
| Environmental Protection Agency |
|
40 CFR 86.1(b)(2)(xxxviii) |
SAE J-2534-1 |
2004 |
Recommended Practice for Pass-Thru Vehicle Programming
Archived
|
Society of Automotive Engineers |
| Environmental Protection Agency |
|
40 CFR 91.6(b)(2) Table |
SAE J-1930 |
1993 |
Electrical/Electronic Systems Diagnostic Terms, Definitions, Abbreviations, and Acronyms
Archived
|
Society of Automotive Engineers |
| Environmental Protection Agency |
|
40 CFR 92.5(c)(1) |
SAE Paper 770141 |
1977 |
Optimization of a Flame Ionization Detector for Determination of Hydrocarbon in Diluted Automotive Exhausts
Archived
|
Society of Automotive Engineers |
| Environmental Protection Agency |
|
40 CFR 272.1651(c)(1) |
NYHWMP |
1988 |
New York State Statutes and Regulations for Approved State Hazardous Waste Management Programs
Archived
|
State of New York (NY) |
| Environmental Protection Agency |
|
40 CFR 272.2101(c)(1) |
SDHWMP |
2014 |
State of South Dakota Statutes and Regulations for Approved State Hazardous Waste Management Programs
Archived
|
State of South Dakota |
| Environmental Protection Agency |
|
40 CFR 60.17(g)(2) |
ASTM A99 |
1987 |
Standard Specification for Ferromanganese
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 60.17(d)(1) |
API 2517 |
1980 |
Evaporation Loss From External Floating-Roof Tanks
Archived
|
American Petroleum Institute |
| Environmental Protection Agency |
|
40 CFR 60.17(q)(1) |
WPCF Method 209A |
1980 |
Total Residue Dried at 103–105 °C, in Standard Methods for the Examination of Water and Wastewater, 15th Edition
Archived
|
Water Pollution Control Federation |
| Environmental Protection Agency |
|
40 CFR 60.17(e)(1) |
APHA Method 303F |
1985 |
Determination of Mercury by the Cold Vapor Technique, Standard Methods for the Examination of Water and Wastewater
Archived
|
American Public Health Association |
| Environmental Protection Agency |
|
40 CFR 60.17(c)(1) |
AHA Catalog No. 057007 |
1993 |
An Ounce of Prevention: Waste Reduction Strategies for Health Care Facilities
Archived
|
American Hospital Association Service, Inc. |
| Environmental Protection Agency |
|
40 CFR 60.17(f)(1) |
ASME Interim Supplement 19.5 |
1971 |
Instruments and Apparatus: Application, part II of Fluid Meters, 6th Edition, chapter 4
Archived
|
American Society of Mechanical Engineers |
| Environmental Protection Agency |
|
40 CFR 60.17(f)(13) |
ASME PTC 4.1 |
1991 |
Power Test Codes: Test Code for Steam Generating Units
Archived
|
American Society of Mechanical Engineers |
| Environmental Protection Agency |
|
40 CFR 60.17(f)(15) |
ASME QRO-1 |
1994 |
Standard for the Qualification and Certification of Resource Recovery Facility Operators
Archived
|
American Society of Mechanical Engineers |
| Environmental Protection Agency |
|
40 CFR 60.17(g)(20) |
ASTM D129 |
1964 |
Standard Test Method for Sulfur in Petroleum Products (General Bomb Method)
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 60.17(g)(24) |
ASTM D129 |
2005 |
Standard Test Method for Sulfur in Petroleum Products (General Bomb Method)
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 60.17(g)(28) |
ASTM D270 |
1965 |
Standard Method of Sampling Petroleum and Petroleum Products
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 60.17(g)(129) |
ASTM D3270 |
1973 |
Standard Test Method for Analysis for Fluoride Content of the Atmosphere and Plant Tissues (Semiautomated Method)
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 60.17(g)(164) |
ASTM D4809 |
1995 |
Standard Test Method for Heat of Combustion of Liquid Hydrocarbon Fuels by Bomb Calorimeter (Precision Method)
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 60.17(g)(169) |
ASTM D5403 |
1993 |
Standard Test Method for Volatile Content of Radiation Curable Materials
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 60.17(g)(175) |
ASTM D5865 |
1998 |
Standard Test Method for Gross Calorific Value of Coal and Coke
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 60.17(g)(177) |
ASTM D6216 |
1998 |
Standard Practice for Opacity Monitor Manufacturers to Certify Conformance with Design and Performance Specifications
Archived
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 60.17(g)(102) |
ASTM D2597 |
1994 |
Standard Test Method for Analysis of Demethanized Hydrocarbon Liquid Mixtures Containing Nitrogen and Carbon Dioxide by Gas Chromatography
Archived
|
ASTM International |