Environmental Protection Agency |
|
40 CFR 136.3(a) Table IC Footnote 5 |
EPA Method 625 |
1982 |
Base/Neutrals and Acids by GC/MS
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 444.12(b)(1) Table (10) |
EPA Method 283.2 |
1978 |
Titanium (Atomic Absorption, Furnace Technique)
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 98.354(g)(3) |
ASTM D1946 |
2006 |
Standard Test Method for Analysis of Reformed Gas by Gas Chromatography
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 63.11647(a)(1)(ii) |
ASTM D6784 |
2008 |
Standard Test Method for Elemental, Oxidized, Particle-Bound and Total Mercury in Flue Gas Generated from Coal-Fired Stationary Sources (Ontario Hydro Method)
|
ASTM International |
Occupational Safety and Health Administration |
|
29 CFR 1910.109(i)(1)(iii)(C) |
NFPA 203M |
1970 |
Manual on Roof Coverings
|
National Fire Protection Association |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IB (28) |
ASTM D1293A |
1999 |
Standard Test Methods for pH of Water, Precise Laboratory Measurement
|
ASTM International |
National Highway Traffic Safety Administration |
|
49 CFR 572.100(b)(1) |
Drawing No. 92041-002 |
1992 |
Skull Assembly
|
Reprographic Technologies |
Coast Guard |
|
46 CFR 28.40(b) |
ABYC E-1 |
1972 |
Bonding of Direct Current Systems
|
American Boat and Yacht Council |
Coast Guard |
|
21 CFR 175.270(b)(5) |
ASTM D1243 |
1979 |
Standard Methods of Test for Dilute Solution Viscosity of Vinyl Chloride Polymers
|
ASTM International |
Mine Safety and Health Administration |
|
30 CFR 70.204(a) |
MSHA Informational Report IR 1240 |
1996 |
Calibration and Maintenance Procedures for Coal Mine Respirable Dust Samplers
|
Mine Safety and Health Administration, U.S. Department of Labor |
Coast Guard |
|
46 CFR 56.60-1(b) Table 56.60-1(b) |
MSS SP-51 |
2003 |
Class 150LW Corrosion Resistant Cast Flanges and Flanged Fittings
|
Manufacturers Standardization Society of the Valve and Fittings Industry |
National Highway Traffic Safety Administration |
|
49 CFR 571.205(a) S5.1.1.7 |
ANSI Z26.1 |
1977 |
Safety Code for Safety Glazing Materials for Glazing Motor Vehicles Operating on Land Highways
|
American National Standards Institute |
Coast Guard |
|
40 CFR 60.17(g)(192) |
ASTM E168 |
1977 |
Standard Practices for General Techniques of Infrared Quantitative Analysis
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 75.6(a)(27) |
ASTM D5373 |
2002 |
Standard Test Methods for Instrumental Determination of Carbon, Hydrogen, and Nitrogen in Laboratory Samples of Coal and Coke
|
ASTM International |
Federal Communications Commission |
|
47 CFR 80.1101(c)(1)(i) |
IMO Resolution A.525(13) |
1983 |
Performance Standards for Narrow-band Direct Printing Telegraph Equipment for the Reception of Navigational and Meteorological Warnings and Urgent Information to Ships
|
International Maritime Organization |
Coast Guard |
|
46 CFR 38.25-3(a)(1) |
ASME B&PV Code |
1986 |
Boiler and Pressure Vessel Code Section V, Nondestructive Examination
|
American Society of Mechanical Engineers |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IB (50) |
APHA Method 4500-P E |
1999 |
Phosphorus, ascorbic acid method
|
American Public Health Association |
Environmental Protection Agency |
|
40 CFR 141.23(k)(1) Table (18) Nitrate |
APHA Method 4500-NO3 D |
1998 |
Nitrate Nitrogen by Selective Electrode
|
American Public Health Association |
Environmental Protection Agency |
|
40 CFR 147.2400(a)(3) |
WAUIC regulations |
1983 |
Washington Administrative Code sections 344-12-001 to 344-12-262 (1983 Ed.)
|
State of Washington |
Research and Special Programs Administration |
|
49 CFR 178.601(g)(8) |
ASTM A366/A 366M |
1991 |
Standard Specification for Steel: Sheet, Carbon, Cold-Rolled, Commercial Quality
|
ASTM International |
Housing and Urban Development Department |
|
24 CFR 3280.705(b)(3) |
ASTM B88 |
1993 |
Standard Specification for Seamless Copper Water Tube
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 98.7(m)(9) |
EPA AP 42, Section 5.2 |
2008 |
AP 42, Section 5.2, Transportation and Marketing of Petroleum Liquids
|
U.S. Environmental Protection Agency |
Coast Guard |
|
46 CFR 160.135-15(e)(1)(iii) |
ASTM D2584 |
2008 |
Standard Test Method of Ignition Loss for Cured Reinforced Resins
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 1065.1010(d)(3) |
IP-501 |
2005 |
Determination of aluminum, silicon, vanadium, nickel, iron, sodium, calcium, zinc and phosphorus in residual fuel oil by ashing, fusion and inductively coupled plasma emission spectrometry
|
Institue of Petroleum |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table ID Footnote 10 |
EPA Method 531.1 |
1995 |
Measurement of N-Methylcarbamoyloximes and N-Methylcarbamates in Water by Direct Aqueous Injection HPLC with Post Column Derivatization -Revision 3.1.
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 141.131(a)(2) |
APHA Method 5910 B |
2000 |
Standard Methods for the Examination of Water and Wastewater
|
American Public Health Association |
Environmental Protection Agency |
|
40 CFR 63.14(g)(35) |
ASTM D3370 |
1976 |
Standard Practices for Sampling Water
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 60.41b Coal |
ASTM D388 |
1991 |
Standard Classification of Coals by Rank
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 63.1512(a) |
ASTM D7520-13 |
2013 |
Standard Test Method for Determining the Opacity of a Plume in the Outdoor Ambient Atmosphere
|
ASTM International |
Food and Drug Administration |
|
21 CFR 165.110(b)(4)(iii)(E)(13)(i) |
EPA-600-4-79-020 |
1983 |
Method 279.2--Atomic Absorption: furnace technique
|
U.S. Environmental Protection Agency |
Labor Department |
|
41 CFR 50-204.2(a)(3) |
49 CFR 179 |
2012 |
Specifications for Tank Cars
|
U.S. Department of Transportation |
Safety and Environmental Enforcement Bureau |
|
30 CFR 250.198(h)(16) |
API MPMS |
2005 |
Chapter 5, Section 1
|
American Petroleum Institute |
Energy Department |
|
10 CFR 430.3(e)(7) |
ASHRAE 41.9 |
2000 |
Calorimeter Test Methods for Mass Flow Measurements of Volatile Refrigerants
|
American Society of Heating, Refrigerating and Air Conditioning Engineers |
National Highway Traffic Safety Administration |
|
49 CFR 571.208 S16.3.2.1.11 |
Drawing No. TE-2504 |
1994 |
H-Point Locator, Hybrid III 5th
|
Reprographic Technologies |
Coast Guard |
|
21 CFR 172.800(b)(2) |
Food Chemicals Codex |
1981 |
Method III of the Fluoride Limit Test
|
National Academy Press |
Rural Utilities Service |
|
7 CFR 1755.97(b)(15) |
RUS Bulletin 1753F-151, Form 515b |
2001 |
Specifications and Drawings for Construction of Underground Plant
|
Rural Utilities Service, U.S. Department of Agriculture |
Environmental Protection Agency |
|
40 CFR 60.17(g)(150) |
ASTM D4177 |
1995 |
Standard Practice for Automatic Sampling of Petroleum and Petroleum Products
|
ASTM International |
Food and Drug Administration |
|
21 CFR 184.1979(b)(1) |
AOAC Official Methods |
1980 |
Official Methods of Analysis
|
AOAC International |
Coast Guard |
|
46 CFR 114.600(b) |
NFPA 17A |
1994 |
Wet Chemical Extinguishing Systems
|
National Fire Protection Association |
National Highway Traffic Safety Administration |
|
49 CFR 572.111(a)(5) |
Drawing No. SA-SID-087 |
1994 |
Pelvic Accelerometer, Sheet 1, Revision H
|
National Highway Traffic Safety Administration, U.S. Department of Transportation |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IF (Toluene) |
EPA Method 524.2 |
1995 |
Volatile Organic Compounds GC/MS Capillary Column
|
U.S. Environmental Protection Agency |
Rural Utilities Service |
|
7 CFR 1755.390(s)(10) |
ICEA S-84-608 |
1988 |
Standard for Telecommunications Cable, Filed, Polyolefin Insulated, Copper Conductor Technical Requirements
|
Insulated Cable Engineers Association |
Pipeline and Hazardous Materials Safety Administration |
|
49 CFR 173.5a(b)(2)(iii) |
ASME B31.4 |
1998 |
Pipeline Transportation Systems for Liquid Hydrocarbons and Other Liquids
|
American Society of Mechanical Engineers |
Pipeline and Hazardous Materials Safety Administration |
|
49 CFR 171.7(a)(3) |
ISO 9809-3 |
2000 |
Gas Cylinders--Refillable Seamless Steel Gas Cylinders--Design, Construction and Testing--Part 3: Normalized Steel Cylinders
|
International Organization for Standardization |
Safety and Environmental Enforcement Bureau |
|
30 CFR 250.198(n)(2) |
COS Safety Publication COS-2-03 |
2012 |
Requirements for Third-party SEMS Auditing and Certification of Deepwater Operations, First Edition
|
Center for Offshore Safety |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IC (104) |
EPA Method 601 |
1982 |
Purgeable Halocarbons
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 799.5087(h)(1)(iii) |
ASTM E729 |
1996 |
Standard Guide for Conducting Acute Toxicity Tests on Test Materials with Fishes, Macroinvertebrates, and Amphibians
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 266, Appendix IX, 2.1.11(2) |
EPA-450-3-82-026 |
1982 |
Gaseous Continuous Emissions Monitoring Systems-Performance Specification Guidelines for SO2, NOX, CO2, O2, and TRS
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 65.2 In light liquid service (3), Note |
ASTM D2879 |
1986 |
Standard Test Method for Vapor Pressure--Temperature Relationship and Initial Decomposition Temperature of Liquids by Isoteniscope
|
ASTM International |
Occupational Safety and Health Administration |
|
29 CFR 1910.156(e)(3)(ii) |
NFPA 1971 |
1975 |
Standard on Protective Ensemble for Structural Fire Fighting
|
National Fire Protection Association |