| Environmental Protection Agency |
|
40 CFR 60.17(g)(2) |
ASTM A99 |
1987 |
Standard Specification for Ferromanganese
|
ASTM International |
| Energy Department |
|
10 CFR 440 Appendix A |
ARI 470 |
1987 |
Desuperheater/Water Heaters
|
Air Conditioning and Refrigeration Institute |
| Environmental Protection Agency |
|
40 CFR 63, Subpart JJJJJJ, Table 5, (1)(d) |
ASTM E711 |
1987 |
Standard Test Method for Gross Calorific Value of Refuse-Derived Fuel by the Bomb Calorimeter
|
ASTM International |
| National Highway Traffic Safety Administration |
|
49 CFR 572.136(b)(1) |
Drawing No. 880105-603 |
1987 |
Lower leg structural replacement
|
Reprographic Technologies |
| National Highway Traffic Safety Administration |
|
49 CFR 572.146(k) |
Drawing No. SA-572-S4 |
1987 |
Accelerometer Specification
|
Reprographic Technologies |
| Energy Department |
|
10 CFR 440 Appendix A |
ANSI Z21.21 |
1987 |
Automatic Valves for Gas Appliances
|
American National Standards Institute |
| National Highway Traffic Safety Administration |
|
49 CFR 572.36(h) |
Drawing No. 78051-46 |
1987 |
Upper leg assembly, left
|
General Motors Corporation |
| National Highway Traffic Safety Administration |
|
49 CFR 572.113 |
Drawing No. 78051-84 |
1987 |
Neck Assembly, SID 50th Percentile Male
|
General Motors Corporation |
| National Highway Traffic Safety Administration |
|
49 CFR 572.126(b) |
Drawing No. 127-4007 |
1987 |
Structural replacement
|
Reprographic Technologies |
| Environmental Protection Agency |
|
40 CFR 147.1700(a)(3) |
NCUIC regulations |
1987 |
Water and Air Resources, N.C. GEN. STAT. §§ 143-211 through 143-215.10 (1987 and Cumm. Supp. 1989)
|
State of North Carolina |
| National Highway Traffic Safety Administration |
|
49 CFR 572.21(i) |
Drawing No. SA 103C 002 |
1987 |
Title not specified
|
National Highway Traffic Safety Administration, U.S. Department of Transportation |
| Environmental Protection Agency |
|
40 CFR 761.19(a)(4) |
ASTM D482 |
1987 |
Standard Test Method for Ash from Petroleum Products
|
ASTM International |
| National Highway Traffic Safety Administration |
|
49 CFR 572.143(c)(2) |
Drawing No. 9001336 |
1987 |
Jam Nut
|
Reprographic Technologies |
| Housing and Urban Development Department |
|
24 CFR 200, Appendix A |
ANSI/NWWDA I.S. 2 |
1987 |
Industry Standard for Wood Windows
|
National Wood Window and Door Association |
| Environmental Protection Agency |
|
40 CFR 58 Appendix E, 12.0(29) |
EPA-450-4-87-009 |
1987 |
Optimum Network Design and Site Exposure Criteria for Particulate Matter, Koch, R.C. and H.E. Rector. EPA Contract No. 68-02-3584
|
U.S. Environmental Protection Agency |
| Environmental Protection Agency |
|
40 CFR 60, Appendix A-8, Method 29, Section 17.0(4) |
EPA Method 1 |
1987 |
Sample and Velocity Traverses for Stationary Sources
|
U.S. Environmental Protection Agency |
| Environmental Protection Agency |
|
40 CFR 60.17(l)(1) |
ISO 8316 |
1987 |
Measurement of Liquid Flow in Closed Conduits-Method by Collection of the Liquid in a Volumetric Tank
|
International Organization for Standardization |
| Environmental Protection Agency |
|
40 CFR 60, Appendix A-8, Method 29, Section 18.0, Table 29-3 |
EPA Method 7041 |
1986 |
Test Methods for Evaluating Solid Waste, Physical/Chemical Methods, SW-846 Third Edition
|
U.S. Environmental Protection Agency |
| Coast Guard |
|
46 CFR 114.600(b) |
ANSI B31.1 |
1986 |
Code for Pressure Piping, Power Piping
|
American National Standards Institute |
| Coast Guard |
|
46 CFR 182.715 |
ANSI B31.1 |
1986 |
Code for Pressure Piping
|
American National Standards Institute |
| Environmental Protection Agency |
|
40 CFR 63.404(a) |
EPA SW-846 |
1986 |
Test Methods for Evaluating Solid Waste, Physical/Chemical Methods
|
U.S. Environmental Protection Agency |
| Environmental Protection Agency |
|
40 CFR 60, Appendix A-8, Method 29, Section 9.2.1 |
EPA Method 6020 |
1986 |
Test Methods for Evaluating Solid Waste, Physical/Chemical Methods, SW-846 Third Edition
|
U.S. Environmental Protection Agency |
| Coast Guard |
|
46 CFR 38.01-5(b) |
ASME B&PV Code |
1986 |
ASME Boiler and Pressure Vessel Code Section V, Nondestructive Examination
|
American Society of Mechanical Engineers |
| Transportation Department |
87 FR 79752 |
49 CFR 178 |
ISO 4706:2008(E) |
1986 |
Hazardous Materials: Editorial Corrections and Clarifications
|
International Organization for Standardization |
| Environmental Protection Agency |
|
40 CFR 52.742(a)(6) |
ASTM D2697 |
1986 |
Standard Test Method for Volume Nonvolatile Matter in Clear or Pigmented Coatings
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 60, Appendix A-8, Method 29, Section 18.0, Table 29-3 |
EPA Method 7060 |
1986 |
Test Methods for Evaluating Solid Waste, Physical/Chemical Methods, SW-846 Third Edition
|
U.S. Environmental Protection Agency |
| Environmental Protection Agency |
|
40 CFR 60.105(b)(1)(iv) |
GPA 2377 |
1986 |
Test for Hydrogen Sulfide and Carbon Dioxide in Natural Gas Using Length of Stain Tubes
|
Gas Processors Association |
| Environmental Protection Agency |
|
40 CFR 60, Appendix A-8, Method 29, Section 11.1.1 |
EPA Method 6010 |
1986 |
Test Methods for Evaluating Solid Waste, Physical/Chemical Methods, SW-846 Third Edition
|
U.S. Environmental Protection Agency |
| Environmental Protection Agency |
|
40 CFR 61.18(d)(1) |
EPA SW-846 |
1986 |
Test Methods for Evaluating Solid Waste, Physical/Chemical Methods, Third Edition, as amended by Revision I, December 1987
|
U.S. Environmental Protection Agency |
| Environmental Protection Agency |
85 FR 40594 |
40 CFR 63 |
SW-846 Test Methods 0010 |
1986 |
Modernizing Ignitable Liquids Determinations
|
U.S. Environmental Protection Agency |
| Environmental Protection Agency |
85 FR 40594 |
40 CFR 260 |
SW- 846 Method 1020C |
1986 |
Modernizing Ignitable Liquids Determinations
|
U.S. Environmental Protection Agency |
| Environmental Protection Agency |
|
40 CFR 266, Appendix IX, 5.0 |
EPA-450-2-78-027R |
1986 |
Guidance on Air Quality Models (Revised)
|
U.S. Environmental Protection Agency |
| Rural Utilities Service |
|
7 CFR 1755.390(a)(7) |
ASTM B694 |
1986 |
Standard Specification for Copper, Copper Alloy, and Copper-Clad Stainless Steel Sheet and Strip for Electrical Cable Shielding
|
ASTM International |
| Coast Guard |
|
46 CFR 38.25-3(a)(1) |
ASME B&PV Code |
1986 |
Boiler and Pressure Vessel Code Section V, Nondestructive Examination
|
American Society of Mechanical Engineers |
| National Highway Traffic Safety Administration |
|
49 CFR 572.123(b) |
Drawing No. 78051-339 |
1986 |
Pivot Pin--Neck Transducer
|
Reprographic Technologies |
| Environmental Protection Agency |
|
40 CFR 60, Appendix A-8, Method 29, Section 18.0, Table 29-3 |
EPA Method 7080 |
1986 |
Test Methods for Evaluating Solid Waste, Physical/Chemical Methods, SW-846 Third Edition
|
U.S. Environmental Protection Agency |
| National Highway Traffic Safety Administration |
|
49 CFR 572.100(b)(1) |
Drawing No. 78051-339 |
1986 |
Pivot Pin--Neck Transducer
|
Reprographic Technologies |
| Environmental Protection Agency |
|
40 CFR 60, Appendix B, PS-1, 16.0(4) |
EPA-340-1-86-009a |
1986 |
Evaluation of Opacity CEMS Reliability and Quality Assurance Procedures. Volume 1
|
U.S. Environmental Protection Agency |
| Housing and Urban Development Department |
|
24 CFR 100.201 Accessible route |
ANSI A117.1 |
1986 |
American National Standard for Buildings and Facilities: Providing Accessibility and Usability for Physically Handicapped People
|
American National Standards Institute |
| Environmental Protection Agency |
|
40 CFR 61.18(d)(1)(iii) |
EPA Method 8240 |
1986 |
Gas Chromatography/Mass Spectrometry for Volatile Organics
|
U.S. Environmental Protection Agency |
| Environmental Protection Agency |
|
40 CFR 300.915(f)(9) |
ASTM D1310 |
1986 |
Standard Test Method for Flash Point and Fire Point of Liquids by Tag Open-Cup Apparatus
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 52.742(a)(14) |
ASTM E300 |
1986 |
Standard Practice for Sampling Industrial Chemicals
|
ASTM International |
| Environmental Protection Agency |
|
40 CFR 60, Appendix A-8, Method 29, Section 18.0, Table 29-3 |
EPA Method 7090 |
1986 |
Test Methods for Evaluating Solid Waste, Physical/Chemical Methods, SW-846 Third Edition
|
U.S. Environmental Protection Agency |
| Environmental Protection Agency |
|
40 CFR 60.17(f)(3) |
ASME MFC-4M |
1986 |
Measurement of Gas Flow by Turbine Meters
|
American Society of Mechanical Engineers |
| Housing and Urban Development Department |
|
24 CFR 200, Appendix A |
ANSI/AAMA 1402 |
1986 |
Aluminum Siding, Soffit, and Fascia
|
American Architectural Manufacturers Association |
| Housing and Urban Development Department |
|
24 CFR 200, Appendix A |
WQA S-400 |
1986 |
Point-of-Use Distillation Drinking Water Systems
|
Water Quality Association |
| Environmental Protection Agency |
85 FR 63394 |
40 CFR 61 |
SW-846 Method 6020B |
1986 |
Test Methods and Performance Specifications for Air Emission Sources
|
U.S. Environmental Protection Agency |
| Environmental Protection Agency |
|
40 CFR 75.6(b)(2) |
ASME MFC-4M |
1986 |
Measurement of Gas Flow by Turbine Meters
|
American Society of Mechanical Engineers |
| Coast Guard |
|
46 CFR 39.1005(f)(1) |
IMO SOLAS |
1986 |
International Convention for the Safety of Life at Sea, Consolidated Text of the 1974 SOLAS Convention, the 1978 SOLAS Protocol, the 1981 and 1983 SOLAS Amendments
|
International Maritime Organization |
| Coast Guard |
|
46 CFR 63.25-3(a) |
ANSI/AGA Z21.22 |
1986 |
Relief Valves and Automatic Shutoff Devices for Hot Water Supply Systems
|
American Gas Association |