Environmental Protection Agency |
|
40 CFR 444.12(b)(1) Table (10) |
EPA Method 283.1 |
1974 |
Titanium (Atomic Absorption, Direct Aspiration)
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 98.354(g)(2) |
ASTM D1945 |
2003 |
Standard Test Method for Analysis of Natural Gas by Gas Chromatography
|
ASTM International |
Food and Drug Administration |
|
21 CFR 184.1660(b) |
Food Chemicals Codex |
1981 |
Propyl Gallate
|
National Academy Press |
Coast Guard |
|
46 CFR 125.180(b) |
UL 489 |
1995 |
Molded-Case Circuit Breakers and Circuit-Breaker Enclosures
|
Underwriters Laboratories, Inc. |
National Highway Traffic Safety Administration |
|
49 CFR 572.132(a) |
Drawing No. 78051-383X |
1987 |
Neck Transducer Structural Replacement
|
General Motors Corporation |
Environmental Protection Agency |
|
40 CFR 63.11647(a)(1)(ii) |
ASTM D6784 |
2002 |
Standard Test Method for Elemental, Oxidized, Particle-Bound and Total Mercury in Flue Gas Generated from Coal-Fired Stationary Sources (Ontario Hydro Method)
|
ASTM International |
Interior Department |
|
43 CFR 11.42(b) |
DOI NRDAM/GLE |
1999 |
CERCLA Type A Natural Resource Damage Assessment Model for Great Lakes Environments, Technical Documentation
|
U.S. Department of the Interior |
Rural Utilities Service |
|
7 CFR 1728.97(a)(4) |
RUS Bulletin 50-19 (DT-7) |
1953 |
RUS Specification for Clevis Bolts
|
Rural Utilities Service, U.S. Department of Agriculture |
Rural Utilities Service |
|
7 CFR 1755.910(a)(7) |
ASTM A569/A 569M |
1991 |
Standard Specification for Steel, Carbon (0.15 Maximum Percent), Hot-Rolled Sheet and Strip, Commercial Quality
|
ASTM International |
Nuclear Regulatory Commission |
|
10 CFR 50.73(b)(2)(ii)(F)(2) |
IEEE 803 |
1983 |
Recommended Practice for Unique Identification in Power Plants and Related Facilities
|
Institute of Electrical and Electronics Engineers |
Environmental Protection Agency |
|
40 CFR 60.17(g)(91) |
ASTM D2369 |
1990 |
Standard Test Method for Volatile Content of Coatings
|
ASTM International |
Federal Motor Carrier Safety Administration |
|
49 CFR 384.225(f) |
CDLIS |
2011 |
Commercial Driver's License Information System (CDLIS) State Procedures Manual, Release 5.2.0
|
American Association of Motor Vehicle Administrators, Inc. |
Coast Guard |
|
46 CFR 52.05-45(a) |
ASME B&PV Code |
2001 |
Boiler and Pressure Vessel Code, Section I, Rules for Construction of Power Boilers
|
American Society of Mechanical Engineers |
Housing and Urban Development Department |
|
24 CFR 200.937(b)(1)(i) |
UM Bulletin 73A |
1978 |
Plastic Bathtubs, Plastic Shower Stalls and Receptors, and Plastic Lavatories
|
U.S. Department of Housing and Urban Development |
Rural Utilities Service |
|
7 CFR 1755.390(d)(5) |
ICEA S-84-608 |
1988 |
Standard for Telecommunications Cable, Filed, Polyolefin Insulated, Copper Conductor Technical Requirements
|
Insulated Cable Engineers Association |
Pipeline and Hazardous Materials Safety Administration |
|
49 CFR 173.420(a)(1)(iii) |
ASME B&PV Code |
1998 |
Boiler and Pressure Vessel Code, Section VIII
|
American Society of Mechanical Engineers |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IF (n-Heptane) |
ASTM D3695 |
1995 |
Standard Test Method for Volatile Alcohols in Water by Direct Aqueous-Injection Gas Chromatography
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 147.2400(a)(2) |
WAUIC regulations |
1984 |
Washington Administrative Code sections 173-218-010 to 173-218-110 (Bureau of National Affairs, 2/29/84)
|
State of Washington |
Occupational Safety and Health Administration |
|
29 CFR 1926.152(g)(2) |
NFPA 385 |
1966 |
Recommended Regulatory Standards for Tank Vehicles for Flammable and Combustible Liquids
|
National Fire Protection Association |
National Highway Traffic Safety Administration |
|
49 CFR 571.131 S6.2.3 |
SAE J-575 |
1983 |
Test for Motor Vehicle Lighting Devices and Components
|
Society of Automotive Engineers |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IC (94) |
EPA Method 625 |
1982 |
Base/Neutrals and Acids by GC/MS
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 141.131(a)(2) |
APHA Method 5310 C |
2014 |
Organic carbon TOC, High-Temperature Combustion Method
|
American Public Health Association |
Environmental Protection Agency |
|
40 CFR 63.14(g)(33) |
ASTM D3173 |
2008 |
Standard Test Method for Moisture in the Analysis Sample of Coal and Coke
|
ASTM International |
Coast Guard |
|
46 CFR 56.01-2(e)(42) |
ASTM A576 |
2012 |
Steel Bars, Carbon, Hot-Wrought, Special Quality
|
ASTM International |
Architectural and Transportation Barriers Compliance Board |
|
36 CFR 1191, App B, 105.2.5 |
NFPA 72 |
1999 |
National Fire Alarm Code
|
National Fire Protection Association |
Coast Guard |
|
46 CFR 160.151-21(j) |
IMO Resolution MSC.293(87) |
2010 |
Annex 7 to MSC 87/26, Report of the Maritime Safety Committee on its Eighty-Seventh Session, Resolution MSC.293(87), Adoption of Amendments to the International Life-Saving Appliance (LSA) Code
|
International Maritime Organization |
Coast Guard |
|
46 CFR 184.240(g) |
ABYC A-1 |
1993 |
Marine Liquefied Petroleum Gas Systems
|
American Boat and Yacht Council |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IC (5) |
APHA Method 6410 B |
2000 |
Base/Neutral and Acid Extractable Compounds by GC/MS
|
American Public Health Association |
Environmental Protection Agency |
|
40 CFR 60.41b Coal |
ASTM D388 |
1990 |
Standard Classification of Coals by Rank
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 63.1510(f)(4) |
ASTM D7520-13 |
2013 |
Standard Test Method for Determining the Opacity of a Plume in the Outdoor Ambient Atmosphere
|
ASTM International |
Minerals Management Service |
|
30 CFR 254.26(e)(2) |
ASTM F818 |
1993 |
Standard Definitions Relating to Spill Response Barriers
|
ASTM International |
Housing and Urban Development Department |
|
24 CFR 3282.12(b)(3)(i)(B)(4) |
SBCCI Standard Plumbing Code |
2014 |
Standard Plumbing Code
|
Southern Building Code Congress International |
Environmental Protection Agency |
|
40 CFR 52, Subpart M |
HISIP |
1979 |
State of Hawaii Implementation Plan with Regulatory and Nonregulatory Revisions
|
State of Hawaii |
Health and Human Services Department |
|
45 CFR 162.1302(b)(1) |
NCPDP Publication |
1999 |
Telecommunication Standard Implementation Guide, Version 5.1
|
National Council for Prescription Drug Programs |
Environmental Protection Agency |
|
40 CFR 60.261(w) Ferrosilicon |
ASTM A100 |
1993 |
Standard Specification for Ferrosilicon
|
ASTM International |
Coast Guard |
|
46 CFR 160.170-21(a)(1) |
IMO MSC.1/Circular 1205 |
2006 |
Guidelines for Developing Operation and Maintenance Manuals for Lifeboat Systems
|
International Maritime Organization |
Environmental Protection Agency |
|
40 CFR 264.1063(d)(1) |
ASTM D2267 |
1988 |
Standard Test Method for Aromatics in Light Naphthas and Aviation Gasoline by Gas Chromatography
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IB (20) |
EPA Method 200.9 |
1994 |
Metals by Graphite Atomic Absorption, Revision 2.2
|
U.S. Environmental Protection Agency |
Food and Drug Administration |
|
21 CFR 101.9(c)(1)(i)(A) |
USDA Handbook 74 |
1973 |
Energy Values of Foods: Basis and Derivation
|
U.S. Department of Agriculture |
Coast Guard |
|
46 CFR 169.703(c)(2) |
NFPA 302 |
1980 |
Fire Protection Standard for Pleasure and Commercial Motor Craft
|
National Fire Protection Association |
Research and Special Programs Administration |
|
49 CFR 179.201-5(b) |
ASTM A240/A 240M |
1999 |
Standard Specification for Heat-Resisting Chromium and Chromium-Nickel Stainless Steel Plate, Sheet and Strip for Fusion-Welded Unfired Pressure Vessels
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 89.6(a)(3) |
ASTM D129 |
1995 |
Standard Test Method for Sulfur in Petroleum Products (General Bomb Method)
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 86.113-04(a)(2)(i) |
CAARB Publication |
1996 |
California Regulatory Requirements Applicable to the National Low Emission Vehicle Program
|
California Air Resources Board |
Environmental Protection Agency |
|
40 CFR 141.23(k)(1) Table (25) Temperature |
APHA Method 2550 |
1998 |
Temperature
|
American Public Health Association |
Coast Guard |
|
46 CFR 111.60-1(d) |
IEEE Std 1580 |
2001 |
Recommended Practice for Marine Cable for Use on Shipboard and Fixed or Floating Platforms
|
Institute of Electrical and Electronics Engineers |
Environmental Protection Agency |
|
40 CFR 136.3(b)(10)(lxvii) |
APHA Method 9221 |
2006 |
Multiple-Tube Fermentation Technique for Members of the Coliform Group
|
American Public Health Association |
Environmental Protection Agency |
|
40 CFR 799.5087(h)(1)(ii) |
ASTM E1147 |
1992 |
Standard Test Method for Partition Coefficient (N-Octanol/Water) Estimation by Liquid Chromatography
|
ASTM International |
Housing and Urban Development Department |
|
24 CFR 3280.604(b)(2) |
FedSpec TT-P-1536A |
1975 |
Plumbing Fixture Setting Compound
|
Federal Specifications Standards and Test Methods |
Coast Guard |
|
46 CFR 160.010-3(a)(2) |
IMO LSA Code |
2010 |
Life-Saving Appliances, including LSA Code
|
International Maritime Organization |
National Highway Traffic Safety Administration |
|
49 CFR 572.170(c)(2) |
SAE J-1733 |
1994 |
Sign Convention for Vehicle Crash Testing
|
Society of Automotive Engineers |