Environmental Protection Agency |
|
40 CFR 136.3(a) Table IG (Organo-tin pesticides) |
EPA Method 200.9 |
1994 |
Metals by Graphite Atomic Absorption, Revision 2.2
|
U.S. Environmental Protection Agency |
Food and Drug Administration |
|
21 CFR 165.110(b)(4)(iii)(E)(10)(i) |
EPA-600-4-91-010 |
1983 |
Method 249.1--Atomic Absorption; direct aspiration
|
U.S. Environmental Protection Agency |
Nuclear Regulatory Commission |
|
10 CFR 50.55a(g)(3)(ii) |
ASME B&PV Code |
2004 |
Boiler and Pressure Vessel Code, Section XI
|
American Society of Mechanical Engineers |
Federal Railroad Administration |
|
49 CFR 229 Appendix F Verification Guidance (a)(6)(v) |
IEC 61508-5 |
1998 |
Part 5: Examples of methods for the determination of safety integrity levels
|
International Electrotechnical Commission |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table ID (20) |
APHA Method 6410 B |
2000 |
Base/Neutral and Acid Extractable Compounds by GC/MS
|
American Public Health Association |
Environmental Protection Agency |
|
40 CFR 52.02(d) |
MOSIP |
1979 |
State Implementation Plan with Regulatory and Nonregulatory Revisions
|
State of Missouri |
Occupational Safety and Health Administration |
|
29 CFR 1910.265(c)(15) |
ANSI Z21.30 |
1964 |
Requirements for Gas Appliances and Gas Piping
|
American National Standards Institute |
Coast Guard |
|
46 CFR 105.01-3(b)(1) |
ASTM D323 |
1979 |
Standard Test Method for Vapor Pressure of Petroleum Products (Reid Method)
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 430, Appendix A, Method 1653 (18.1) |
NCASI Method CP-86.01 |
1986 |
Chlorinated Phenolics in Water by In Situ Acetylation/GC/MS Determination
|
National Council of the Paper Industry for Air and Stream Improvement, Inc. |
Environmental Protection Agency |
|
40 CFR 80.47(p)(2)(i) |
ASTM D6299 |
2013 |
Standard Practice for Applying Statistical Quality Assurance Techniques to Evaluate Analytical Measurement System Performance
|
ASTM International |
Coast Guard |
|
46 CFR 154.1(b) |
ASTM A20/A 20M |
1997 |
Standard Specification for General Requirements for Steel Plates for Pressure Vessels
|
ASTM International |
Coast Guard |
|
46 CFR 160.171-3(b) |
ASTM C518 |
1991 |
Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus
|
ASTM International |
Coast Guard |
|
46 CFR 169.703(c)(5) |
NFPA 302 |
1980 |
Fire Protection Standard for Pleasure and Commercial Motor Craft
|
National Fire Protection Association |
Housing and Urban Development Department |
|
24 CFR 3280.707(f) |
UL 307A |
1995 |
Liquid Fuel-Burning Heating Appliances for Manufactured Homes and Recreational Vehicles, Seventh Edition with 1997 Revisions
|
Underwriters Laboratories, Inc. |
Coast Guard |
|
46 CFR 111.33-11 |
ABS Publication |
2003 |
Rules for Building and Classing Steel Vessels
|
American Bureau of Shipping |
Environmental Protection Agency |
|
40 CFR 264.1035(b)(4)(iii) |
EPA-450-2-81-005 |
1981 |
Air Pollution Training Institute Course 415: Control of Gaseous Emissions
|
U.S. Environmental Protection Agency |
Housing and Urban Development Department |
|
24 CFR 200.949(a)(1)(vii) |
ISDSI 106 |
1980 |
Test Procedures and Acceptance Criteria for Physical Endurance for Prime Painted Steel Surfaces for Steel Doors and Frames
|
Insulated Steel Door Institute |
Research and Special Programs Administration |
|
42 CFR 460.72(b)(5)(iv) |
NFPA 101 |
2000 |
Life Safety Code, as amended by NFPA Temporary Interim Amendment 00-1(101)
|
National Fire Protection Association |
Rural Utilities Service |
|
7 CFR 1755.870(a)(7) |
NFPA 70 |
1993 |
National Electrical Code
|
National Fire Protection Association |
Environmental Protection Agency |
|
40 CFR 60.664(e)(2)(ii) |
ASTM D1946 |
1977 |
Standard Method for Analysis of Reformed Gas by Gas Chromatography
|
ASTM International |
Occupational Safety and Health Administration |
|
29 CFR 1910.6(q)(12) |
NFPA 58 |
1969 |
Standard for the Storage and Handling of Liquefied Petroleum Gases
|
National Fire Protection Association |
Housing and Urban Development Department |
|
24 CFR 200.926a(c)(3) |
ANSI A58.1 |
1982 |
Building Code Requirements for Minimum Design Loads in Buildings and Other Structures
|
American National Standards Institute |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IC (20) |
EPA Method 1624 B |
1990 |
Volatile Organic Compounds by Isotope Dilution Purge & Trap GC/MS
|
U.S. Environmental Protection Agency |
Energy Department |
|
10 CFR 430.3(n)(1) |
OSA Publication |
1968 |
Computation of Correlated Color Temperature and Distribution Temperature, A.R. Robertson, Journal of the Optical Society of America, Volume 58, Number 11, November 1968, pages 1528-1535
|
Optical Society of America |
Coast Guard |
|
46 CFR 164.012(a)(2) |
NFPA 255 |
2006 |
Method of Test of Surface Burning Characteristics of Building Materials
|
National Fire Protection Association |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IB (31) |
ASTM D1426A |
2008 |
Ammonia by Nesslerization
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 141.23(k)(1) Table Note 3 |
Annual Book of Standards |
1996 |
Annual Book of ASTM Standards, Vols. 11.01 and 11.02
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 143.4(b) Table (Total Disolved Solids) |
APHA Method 2540 C |
1997 |
APHA Standards On-line, Solids, Total Dissolved Solids Dried at 180 degrees C
|
American Public Health Association |
Environmental Protection Agency |
|
40 CFR 63.3521(c) |
ASTM D1475 |
1990 |
Standard Test Method for Density of Liquid Coatings, Inks, and Related Products
|
ASTM International |
Food and Drug Administration |
|
21 CFR 177.1520(d)(1) |
ASTM D1505 |
1979 |
Standard Test Method for Density of Plastics by the Density-Gradient Technique
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table IH Footnote 20 |
EPA Method 1603 |
2009 |
Escherichia coli (E. coli) in Water by Membrane Filtration Using Modified membrane-Thermotolerant Escherichia coli Agar (Modified mTEC)
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 141.25(a) Table |
EPA Method 200.8 |
1994 |
Metals by ICP-MS
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 60.4415(a)(1)(i) |
ASTM D129 |
2005 |
Standard Test Method for Sulfur in Petroleum Products (General Bomb Method)
|
ASTM International |
Energy Department |
|
10 CFR 440 Appendix A |
ASTM C516 |
1990 |
Standard Specification for Vermiculite Loose Fill Thermal Insulation
|
ASTM International |
Occupational Safety and Health Administration |
|
29 CFR 1910.261(g)(15)(iv) |
ANSI Z99.1 |
1969 |
Title Not Found
|
American National Standards Institute |
Research and Special Programs Administration |
|
49 CFR 171.7(a)(3) |
ASTM A20/A 20M |
1993 |
Standard Specification for General Requirements for Steel Plates for Pressure Vessels
|
ASTM International |
Energy Department |
|
10 CFR 433.2 |
ASHREA 90.1 |
2007 |
Energy Standard for Buildings Except Low-Rise Residential Buildings
|
American Society of Heating, Refrigerating and Air Conditioning Engineers |
Environmental Protection Agency |
|
40 CFR 75, Appendix G, Section 2.1.2 |
ASTM D5373 |
2002 |
Standard Methods for Instrumental Determination of Carbon, Hydrogen, and Nitrogen in Laboratory Samples of Coal and Coke
|
ASTM International |
Federal Communications Commission |
|
47 CFR 15.38(b)(3) |
SCTE 54 (formerly DVS 241) |
2003 |
Digital Video Service Multiplex and Transport System Standard for Cable Television
|
Society of Cable Telecommunications Engineers |
Environmental Protection Agency |
|
40 CFR 60, Appendix B, PS-1, 8.1(3)(ii) |
ASTM D6216 |
1998 |
Standard Practice for Opacity Monitor Manufacturers to Certify Conformance with Design and Performance Specifications
|
ASTM International |
Environmental Protection Agency |
|
40 CFR 60.17(g)(28) |
ASTM D270 |
1965 |
Standard Method of Sampling Petroleum and Petroleum Products
|
ASTM International |
Federal Motor Carrier Safety Administration |
|
49 CFR 393.55(b) |
FMVSS 105 |
1998 |
Hydraulic and Electric Brake Systems
|
National Highway Traffic Safety Administration, U.S. Department of Transportation |
Coast Guard |
|
46 CFR 160.060-3(c) |
Federal Standard 191 |
1978 |
Textile Test Method 5610
|
Federal Specifications Standards and Test Methods |
National Highway Traffic Safety Administration |
|
49 CFR 572.177(b)(5) |
Part No. 420-0000 |
2011 |
Engineering drawings and specifications
|
National Highway Traffic Safety Administration, U.S. Department of Transportation |
Environmental Protection Agency |
|
40 CFR 63.14(g)(72) |
ASTM D6323 |
1998 |
Standard Guide for Laboratory Subsampling of Media Related to Waste Management Activities
|
ASTM International |
Energy Department |
|
10 CFR 430 Subpart B, App. P, 2 |
ANSI Z21.56 |
1994 |
Gas-Fired Pool Heaters
|
American National Standards Institute |
Food and Drug Administration |
|
21 CFR 184.1150(b) |
Food Chemicals Codex |
1996 |
Bacterially-derived protease enzyme preparation
|
National Academy Press |
National Highway Traffic Safety Administration |
|
49 CFR 571.5(l)(21) |
SAE J-787b |
1966 |
Motor Vehicle Seat Belt Anchorage
|
Society of Automotive Engineers |
Environmental Protection Agency |
|
40 CFR 136.3(a) Table ID (42) |
EPA Method 617 |
1993 |
Organohalide Pesticides and PCBs by Liquid/Liquid Extraction and GC/ECD
|
U.S. Environmental Protection Agency |
Environmental Protection Agency |
|
40 CFR 60, Appendix A-7, Method 24, Section 11.2.2 |
ASTM D2369 |
1993 |
Standard Test Method for Volatile Content of Coatings
|
ASTM International |